DIY Solar or Hire an Installer? What to Know Before You Start

Short answer: small, low-voltage off-grid systems, like a panel and battery for an RV, van, boat, shed or campsite, are often set up by owners themselves. Anything wired into your home's electrical panel or connected to the power grid should be done by a licensed electrician, with permits and an inspection.

When does DIY solar make sense?

DIY usually works well when the system:

  • runs at 12V or 24V and isn't connected to your house wiring,
  • powers an RV, van, boat, shed, cabin lights or camping gear,
  • uses parts meant to work together, such as a panel, a charge controller and a battery.

Even small systems store a lot of energy, so treat them with respect.

When should I hire a licensed electrician?

  • The system connects to your home's main electrical panel.
  • You want to feed power back to the grid, which needs approval from your local utility.
  • You're putting panels on a house roof, which may need a structural check.
  • You're adding an inverter that powers household circuits, or a transfer switch for backup power.

Most places require a permit and an inspection for this kind of work. In Ontario, electrical permits and inspections go through the Electrical Safety Authority (ESA). Elsewhere, check with your local building or electrical authority.

DIY safety basics for 12V and 24V systems

  1. Fuse it. Put a fuse or breaker on the positive cable, close to the battery. A short circuit across a battery can overheat cables and start a fire.
  2. Use the right cable size. Thin cable gets hot and wastes power. Size it for the current and the length of the run.
  3. Use a charge controller. Panels should charge a battery through a charge controller so the battery isn't overcharged.
  4. Match the charge settings to the battery. LiFePO4, lead-acid and sodium-ion batteries need different charge voltages.
  5. Connect in the right order. Follow your charge controller's manual. Most say to connect the battery first, then the panels, and to disconnect in reverse.
  6. Mount everything securely, away from fuel, water and heat, with airflow around the battery and controller.

Where should the panels go?

  • RV or van roof: rigid panels on mounts, or flexible panels where weight and height matter.
  • Ground or pole mount: easy to angle toward the sun and keep clear of snow. Good for cabins and sheds.
  • Portable: foldable panels you set up at camp and move to follow the sun.

Shade is the biggest enemy. Even a branch shading part of a panel can cut its output a lot, so pick a spot with open sky to the south (in the northern hemisphere).

Checklist before you start

  • Work out your daily power use and size the battery and panels. Our RV and van sizing guide walks through it.
  • Check which permits apply where you live.
  • Check your insurance, especially for buildings and vehicles.
  • Read the battery and charge controller manuals before wiring anything.
  • If you're hiring someone, get two or three quotes and ask about licences, insurance and their workmanship warranty.

FAQ

Can I install solar panels on my house myself?

A skilled owner may be able to mount them, but connecting to household wiring or the grid needs a licensed electrician and permits in most places.

How long does a home installation take?

The physical work on a home rooftop system often takes a few days. Permits, inspections and utility approval can add several weeks.

Can panels go on a flat roof?

Yes. Tilted mounts or weighted (ballasted) racks angle the panels toward the sun.

Planning an off-grid setup? Browse solar panels and charge controllers and solar batteries, or email radiantgridsolar@gmail.com with questions.


Leave a comment