How to Size a Solar Battery and Panels for Your RV or Van

Before you buy a battery or solar panels for your RV, van or boat, it helps to know how much power you actually use. Get that number first and the rest is simple arithmetic. This guide walks through it with a worked example you can copy.

Step 1: Add up what you use in a day

List everything you'll run from the battery. For each item, multiply its power in watts by the hours you use it each day. That gives you watt-hours (Wh). The watts are usually printed on the device label or its charger.

Here's an example for a camper van:

Device Watts Use per day Wh per day
LED lights 10 5 hours 50
Water pump 60 30 minutes 30
12V compressor fridge Varies Cycles on and off About 400
Laptop 60 2 hours 120
2 phones One charge each About 30
Roof fan 20 6 hours 120
Total 750

A fridge switches on and off through the day, so look for the daily energy figure in its manual rather than multiplying its watts by 24.

Then add about 20% for losses in wiring and inverters. In this example, 750 Wh becomes about 900 Wh a day.

Step 2: Size the battery

Battery capacity is usually listed in amp-hours (Ah). To turn watt-hours into amp-hours, divide by the battery voltage. A 12V lithium iron phosphate (LiFePO4) battery is 12.8V nominal.

You also don't want to run a battery flat every day. A common rule is to plan on using about 80% of a LiFePO4 battery's capacity, and about 50% of a lead-acid battery's.

For the example: 900 Wh / 0.8 / 12.8V = about 88 Ah for one day.

Next, decide how many days you want to get through without sun. Two days is a sensible starting point for cloudy weather, which brings the example to about 176 Ah. A 200 Ah LiFePO4 battery, or two 100 Ah batteries wired in parallel, covers it.

Step 3: Size the solar panels

Panels are rated in watts under ideal test conditions. In real use, heat, angle, dirt and shade cut that output, so plan on getting about 75% of the rating.

The other number you need is peak sun hours: the number of hours of full-strength sun your location gets in a day, on average. In much of Canada and the northern US it's roughly 4 to 5 hours in summer and 1 to 2 hours in winter. Online solar maps show the figure for your area.

Panel watts = daily Wh / peak sun hours / 0.75

For the example in summer: 900 / 4 / 0.75 = 300 W of panels. In winter you'd need several times that, which is why many people top up from shore power or a generator in the colder months.

Step 4: Pick a charge controller

A charge controller sits between the panels and the battery and stops the battery from overcharging. To size it, divide your panel watts by the battery voltage and add 25% headroom.

For the example: 300 W / 12V x 1.25 = about 31 A, so a 40 A controller is a good fit.

  • MPPT controllers get more out of your panels, especially in cold weather and with larger setups. They cost more.
  • PWM controllers cost less and work fine for small systems.
  • Whichever you choose, make sure it has a charging setting for your battery type (LiFePO4, lead-acid or sodium-ion), or lets you set the charge voltages yourself.

Step 5: Plan for the cold

Most LiFePO4 batteries should not be charged below freezing (0°C) unless they have built-in low-temperature protection or heating. If your RV or cabin sits unheated in winter, check the battery's charging temperature range before you buy, or look at a chemistry made for the cold, such as sodium-ion.

Quick reference

How you use power Daily use 12V LiFePO4 battery (2 days) Panels (summer)
Light: lights, phones, water pump About 300 Wh About 100 Ah 100 to 150 W
Moderate: add a fridge, laptop and fan About 750 Wh About 200 Ah About 300 W
Heavy: add a coffee maker, microwave or induction cooktop 2,000 Wh or more About 450 Ah or more 800 W or more

At the heavy end, a 24V system is often simpler, because it halves the current and lets you use thinner cables.

Shop or ask us

Browse our solar batteries and solar panels. Not sure about your numbers? Email your device list to radiantgridsolar@gmail.com and we'll help you size your setup.

These figures are estimates for planning. Real results depend on your devices, location, weather and installation. For permanent wiring, use a qualified installer.


Leave a comment